Analog Input (en)

Analoger Input (DE)

An analog input can measure a voltage difference. Many phenomena can be measured with simple sensors that output analog voltage value, for example, sound, light intensity, and or preasure. Therefore the Arduino offers the analog inputs (A0-A5) to read such values. To be able to detect a voltage difference (analog signal), the Arduino has a 6 channel, 10-bit analog to digital converter (AD converter). A resolution of 10-bit means that the Arduino detects a voltage difference from 0V to 5V with a resolution of 10-bit. It, therefore, delivers 1024 different values for this range (this corresponds to an accuracy of 4.9 mV per step).
For our purposes, a 10-bit resolution is sufficient. However, there are much more accurate analog to digital converters, with say 16-bit (65535 values) or even 32-bit (approx. 4.3 million values). 

Function

To read a signal at an analog pin we use the function analogRead(Pin_Number). This function directly returns us a number between 0 and 1024. We don't need to call pinMode(PIN, MODE) in setup() for this function as we do for digital pins.

Example with a Photo Resistor 

One type of simple sensor is a photoresistor. It changes its electrical conductivity (resistance) depending on the incidence of brightness and can therefore also be called a brightness sensor. To connect the sensor we use a so-called voltage divider circuit.

Voltage Divider

With the help of a voltage divider, we can measure differences in the voltage ratio of two resistors between 0V and Vcc (in our case 5V). Typically one of the resistors is a sensor (variable resistor) and one is a fixed resistor. The circuit looks like this:

Die entsprechende Formel, deren Herleitung vom Ohmschen Gesetz in diesem Wikipedia Eintrag erläutert wird lautet:

Vres = Vcc*(R2/(R1+R2))

Vres = Resultierende Spannung
Vcc = Anliegende Spannung (5V)
R1 = Erster Widerstand (Fotoresistor)
R2 = Zweiter Widerstand (Festwiderstand)

Für unseren Fotoresistor ergibt sich also folgende Schaltung…

Example-Code

For the code, let's output the values read from Arduino via the Serial Monitor (see: Serial).

#define BRIGHTNESS A0
void setup()
{
  Serial.begin(9600);
}
void loop()
{
  int reading = analogRead(BRIGHTNESS); // We get the sensor value here
  Serial.println(reading); // We send the message to serial 
}

If we look at the values in the Serial Monitor, we see that they change as soon as we hold our hand over the sensor, for example.

Potentiometers

A potentiometer is a special form of a variable resistor since it functions in itself as a voltage divider. This makes it perfect for generating a fast analog input. The function can be simplified as follows:

To connect the potentiometer to the Arduino we use the following circuit:

Exercises:

1. Use the circuit with the photoresistor to control the brightness of an LED.

2. Use a potentiometer to control the blinking speed of an LED. 3.

3. Use the potentiometer to control three LEDs one after the other (Poti left = LED_1, Poti middle = LED_2, Poti right = LED_3).

Usefull Functions

map() 
Map a value in one range to a new scale
e.g. map(Value, Start_Old_Range, End_Old_Range, Start_New_Range, End_New_Range)

Or in our case 

map(Value, 0, 1023, 0, 254)

constrain()
Limits a value to a specific range
e.g. constrain(WERT, 0, 255)